#Turn on a dim3 full#

This can happen with opened datalines, particularly if the DIMM causes channel training to fail. The LED is lit to indicate a defective DIMM that is rendering a channel unusable. This problem will not occur if the failing DIMM was either of the first two (2) DIMMs in a three (3) slot channel, or the first in a two (2) slot channel. Channels C and F each have only two (2) DIMM slots. Channels A, B, D, and E each have three (3) DIMM slots.

To re-enable a DIMM, highlight/select that DIMMįor the listed product, there are six (6) memory slot channels.

Select the Memory option to view or change.If you do not type the administrator password, a limited Setup utility menu is available.

#Turn on a dim3 full#

If you have set both a power-on password and an administrator password, you must type the administrator password to access the full Setup utility menu. When prompted, press F1 to enter the Setup screen.If the logs indicate that other DIMMs have been disabled, re-enable the DIMMs by continuing to perform the following steps: Refer to the Problem Determination and Service Guide instruction to Replace/Remove the failing DIMM. When a DIMM failure occurs, review the Event Logs to determine which DIMM is the failing DIMM. The system has the symptom described above. iDataPlex dx360 M2 Server, Type 7323, any model.iDataPlex dx360 M2 Server, Type 7321, any model.iDataPlex dx360 M2 Server, Type 6380, any model.The system may be any of the following IBM servers:

This is working as designed (see the Additional information section). The Event logs will show the following:.All DIMMs in the same channel (D1 and D2) will become disabled (powered off).DIMMs are installed in D1-D3 (Channel D) and the DIMM in slot D3 becomes defective.This occurs only when the last DIMM in a channel fails. In some cases, when a Dual In-line Memory Module (DIMM) fails, the failed DIMM along with all of the other DIMMs in the same channel are reported to be disabled in the logs.